Not registered? Then you're not seeing all there is to see. Do you want to contribute? Register now by clicking HERE!
 
  Forums  
 
Advertise with Classic Motorcycling Australia
Advertise with Classic Motorcycling Australia
 
 All Forums
 Classic, Historic & Post Classic Motorcycling
 General Comments
 P3 500 single crank set ups?
 New Topic  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  
  Current Topic Rating: Total Rating: 0 | Join the Forum to Rate this Topic at: Classic Motorcycling Australia Forums  

Ben
Honda CB350 Racers Promotion - Moderator

Victoria


288 Posts

Posted - 13 Nov 2008 :  8:47:14 PM  Show Profile Send Ben a Private Message  

 
Hi All,

Thanks to those who provided some leads on contacts for crank works.

The next question is - what are you guys using in P3 crank/rod components? That is, what rods, bearings, crank pins etc? I know that most are using contemporary set-ups from modern bikes adapted to fit, but would like to hear what components have been used and what people are having success with to help with my new P3 project.

I have some ideas, but guidance would be appreciated.

Thanks and Cheers,
Ben.
 

 
Try Everything
  Previous Topic Topic Next Topic  
 New Topic  Topic Locked
 Printer Friendly
Jump To:
Classic Motorcycling Australia Forums © 2000 - 2025 Go To Top Of Page
This page was put together in 1.47 seconds. Snitz Forums 2000


 
 
 
Copyright © 2000 - 2025 by Classic Motorcycling Australia | Web design by: Greening Computer Services